Plastic Mold Of Emergency Reflective Triangles Warning

The general principle of the reflective triangle warning plastic mold injection

1. The wall thickness range of reflector (Tooth tip to female die surface)

* Small dimension reflector: the wall thickness between 1~1.3 mm

* Large dimension reflector: the wall thickness between 1.5~2 mm

2. Molding conditions

* Mold temperature: Should be 80 degrees Celsius above

* Cycle time: Especially focus on hold pressure

* Injection pressure control: Depends on the machine, but not too high

* Feeding tube temperature: Depends on the material

3. Precaution of Molding

* Please don’t injection with a cold material, it will scratch the reflex surface (Can not be repaired)

* During injection, if need to use a release agent to help to release, please use waterborne type in case it affects the photometric test value

* The material of injection should be strictly controlled, definitely never use recycling or secondary

* If the reflector needs to do vacuum evaporation, the photometric test value predestine reduces about 50%. It should be noted to inspect the valid reflection area of the initial design and related optometry margin