Key Points Of Making Plastic Dustbin Mould

The requirement of making plastic dustbin mould is high, usually, the raw material is PP which can produce high glossy and smooth dustbins. Then labelling the printing when producing, the dustbins seem high-end and top seller. So for making a good quality dustbin, the mould is one of the most important factors. How to make a good plastic dustbin mould? Here are some key points you need to pay attention to:

*mould assembly

The assembly of mould is just like machine assembly, every part, even every screw can't go wrong, otherwise will cause bad effects to range from mild product defects to serious mould damage & useless. So when assembling the mould, must be careful, especially the waterline and screw holes, must cleaning these places.

*hot runner or cold runner

The effect of the runner to mould is less. As for some customers, they will have a requirement on the brand of a hot runner, which have good quality and after-sales service. If you have a limit on finance, you can choose a local brand hot runner, which also in good quality. If choosing the cold runner, you may need to pay attention to the problems on the gate, injection pressure, injection balance, etc.

*the cooling water line

It's well-known that the cooling water line is important for mould. Through such kind of environment that with a rapid increment of salary and cost, even decrease one second can save more cost for the company. So the well cooling water line design need to concern the arrangement, the diameter, etc.

*the mould maintenance

The maintenance of moulds including producing and after production. During production, need to pay attention to the mould moving not to damage the mould. The more important is after production, need to clean the mould and spray the anti-rust oil. So that the mould life is longer.

Contact SWY MOULD (Email: [email protected] or Phone: +86 157 5766 8880) to get more information on plastic moulds.